Be sure to bookmark this page for future reference.

Supplies
Prepare the needed supplies to make a daisy hair clip. Covered alligator clip (green), (4) 3 inches of 3/8″ grosgrain ribbon (white), 5 inches of 3/8″ grosgrain ribbon (green) & 12 inches of 3/8″ grosgrain ribbon (yellow).
Step 1
Take the 3 inch length ribbons and stack them one on top of the other. Take the threaded needle and stick it into the center point of the ribbons. Do not pull the needle all the way through the ribbons.
Step 2
Fan out each of the ribbon ends so they are evenly spread.
Step 3
Take the top ribbon end and carefully push it through the needle and down. Continue working your way around the bow clockwise, pushing each of the ribbon ends through the needle and down.
Step 4
Pull the needle all the way through and pass the needle back through the center of the bow. Return the needle back through the center to the back of the bow.
Step 5
Knot the thread to the back of the bow and cut off the remaining thread with scissors.
Step 6
Take the 12 inch length of ribbon and mark the center with a pencil.
Step 7
Fold the ribbon at the center point, forming a right angle.
Step 8
Take the end that is underneath and fold it back over the center of the ribbon. Now fold the opposite end back over the center of the ribbon. Alternate sides and continue folding the ends of the ribbon back over the center until most of the ribbon has been folded into a stack.
Step 9
Pinch the ends of the ribbon and release the stack.
Step 10
Pull one end of the ribbon while letting the ribbon slide through your fingers to form a flower bud. Stop pulling once the center of the flower is pulled in. Cut off the excess ribbon with scissors.
Step 11
Apply glue to the back side of the flower bud to Secure it in place.
Step 12
Take the 5 inch length of ribbon and mark the center with a pencil.
Step 13
Form a loop by bringing one end of the ribbon over to the center mark. Attach the end of the ribbon with glue at the center mark.
Step 14
Form another loop by bringing the other end of the ribbon over to the center mark. Attach the end of the ribbon with glue at the center mark.
Step 15
Apply glue to the top of the covered alligator clip and attach the flower bow.
Step 16
Apply glue to the center of the flower bow and attach the flower bud. Finally, open the alligator clip and attach the figure eight to the inside of the clip with glue.
Finished Daisy Hair Clip
Congratulations, your Daisy Hair Clip is now finished!